Comparison of Calculated and Measured Thermal Stresses in Asphalt Concrete

Authors

  • Marek Pszczoła Dept of Highway Engineering, Gdansk University of Technology, Narutowicza str. 11/12, 80–233 Gdańsk, Poland
  • Józef Judycki Dept of Highway Engineering, Gdansk University of Technology, Narutowicza str. 11/12, 80–233 Gdańsk, Poland

DOI:

https://doi.org/10.3846/bjrbe.2015.05

Keywords:

thermal stresses, low temperatures, creep test, stiffness modulus

Abstract

The paper presents the comparison of calculated and measured thermal stresses induced in restrained asphalt concrete specimens by cooling. Thermal stresses were measured in the Thermal Stress Restrained Specimen Test. The calculations of thermal stresses were performed with the use of a theoretical formula based on the temperature dependent stiffness modulus. The novel approach applied in this paper was that the stiffness modulus of asphalt concrete which was used in calculations was measured in a creep test at low temperatures on the same material which was used in the Thermal Stress Restrained Specimen Test. Realistic values of stiffness moduli resulted in a good compatibility between calculated and measured thermal stresses. The creep test at low temperatures was performed in bending according to the method developed at the Gdansk University of Technology. Three types of bitumen were used to produce asphalt concrete. The lowest thermal stresses were induced in the Thermal Stress Restrained Specimen Test in asphalt concrete with 50/70 multigrade bitumen, next with DE 80B SBS polymer modified bitumen and the highest with 50/70 plain bitumen.

References

Arand, W. 1990. Behaviour of Asphalt Aggregate Mixes at Low Temperatures, in Proc. of the 4th International RILEM Symposium Mechanical Tests for Bituminous Mixes, Characterization, Design, and Quality Control. 23–25 October 1990, Budapest, Hungary. Chapman and Hall, 68–84.

Bražiūnas, J.; Sivilevičius, H.; Virbickas, R. 2013. Dependences of SMA Mixture and Its Bituminous Binder Properties on Bitumen Batching System, Mixing Time and Temperature on Asphalt Mixing Plant, Journal of Civil Engineering and Management 19(6): 862–872. http://dx.doi.org/10.3846/13923730.2013.843587

Bražiūnas, J.; Sivilevičius, H. 2010. The Bitumen Batching System’s Modernization and Its Effective Analysis at the Asphalt Mixing Plant, Transport 25(3): 325–335. http://dx.doi.org/10.3846/transport.2010.40

Ceylan, H.; Gopalakrishnan, K.; Lytton, R. L. 2011. Neural Networks Modelling of Stress Growth in Asphalt Overlays Due to Load and Thermal Effects during Reflection Cracking, Journal of Materials in Civil Engineering 23(3): 221–229. http://dx.doi.org/10.1061/(ASCE)MT.1943-5533.0000153

Chiasson, A.; Yavuzturk, C.; Ksaibati, K. 2008. Linearized Approach for Predicting Thermal Stresses in Asphalt Pavements Due to Environmental Conditions, Journal of Materials in Civil Engineering 20(2): 118–127. http://dx.doi.org/10.1061/(ASCE)0899-1561(2008)20:2(118)

Das, P. K. 2012. Thermally Induced Fracture Performance of As phalt Pavements. Licentiate thesis, KTH, Royal Institute of Technology, Stockholm, Sweden. TRITA-TSC-LIC 12-006, ISBN 978-91-85539-91-8.

Faarar, M. J.; Hajj, E. Y.; Planche, J. P.; Alavi, M. Z. 2013. A Method to Estimate the Thermal Stress Build-Up in an Asphalt Mixture from a Single-Cooling Event, Road Materials and Pavement Design 14 (Supplement 1): 201–211. http://dx.doi.org/10.1080/14680629.2013.774756

Hall, M. R.; Dehdezi, P.; Dawson, A.; Grenfell, J.; Isola, R. 2012. Influence of the Thermophysical Properties of Pavement Materials on the Evolution of Temperature Depth Profiles in Different Climatic Regions, Journal of Materials in Civil Engineering 24(1): 32–47. http://dx.doi.org/10.1061/(ASCE)MT.1943-5533.0000357

Heukelom, W.; Klomp, A. J. G. 1964. Road Design and Dynamic Loading, in Proc. of the Association of Asphalt Paving Technologists 33: 92–125.

Hills, J. F.; Brien, D. 1966. The Fracture of Bitumens and Asphalt Mixes by Temperature Induced Stresses, in Proc. of the Association of Asphalt Paving Technologists 35: 292–309.

Hiltunen, D. R.; Roque, R. 1994. A Mechanistic-Based Prediction Model for Thermal Cracking in Asphaltic Concrete Pavements, in Proc. of Association of Asphalt Paving Technolo- gists 63: 81–117.

Judycki, J. 1990. Bending Test of Asphaltic Concrete Mixtures under Statical Loading, in Proc. of the 4th International RILEM Symposium Mechanical Tests for Bituminous Mixes, Characterization, Design, and Quality Control. 23–25 October 1990, Budapest, Hungary. Chapman and Hall, 207–233.

Juknevičiutė-Žilinskienė, L. 2010. Methodology for the Evaluation of the Effect of the Climate of Lithuania on Road Construction and Climatic Regioning, The Baltic Journal of Road and Bridge Engineering 5(1): 62–68. http://dx.doi.org/10.3846/bjrbe.2010.09

Jung, H. H.; Vinson, T. S. 1994. Low-Temperature Cracking – Test Selection. Strategic Highway Research Program Report, SHRP-A-10. 106 p.

Leonovich, I.; Melnikova, I.; Puodžiukas, V. 2013. Estimation оf the Cracking Probability in Road Structures by Modelling оf External Influences, The Baltic Journal of Road and Bridge Engineering 8(4): 240–249. http://dx.doi.org/10.3846/bjrbe.2013.31

Marasteanu, M.; Buttlar, W.; Bahia, H.; Williams, Ch. 2012. Investigation of Low Temperature Cracking in Asphalt Pavements. National Pooled Fund Study – Phase II Mn/RC 2012-23.

Marasteanu, M.; Li, X.; Clyne, T. R.; Voller, V. R.; Timm, H. D.; Newcomb, D. E. 2004. Low Temperature Cracking of Asphalt Concrete Pavements. Report No. Mn/DOT 2004-23. University of Minnesota, Minneapolis.

Marasteanu, M.; Zofka, A.; Turos, M.; Li, Xinju; Velasquez, R.; Li, X.; Buttlar, W.; Paulino, G.; Braham, A.; Dave, E.; Ojo, J.; Bahia, H.; Williams, Ch.; Bausano, J.; Gallistel, A.; McGraw, J. 2007. Investigation of Low Temperature Cracking in Asphalt Pavements. National Pooled Fund Study Report No. 776 Mn/RC 2007-43.

Monismith, C.; Secor, G.; Secor, K. 1965. Temperature Induced Stresses and Deformations in Asphalt Concrete, in Proc. of the Association of Asphalt Paving Technologists 34: 248–285.

Prieto-Muñoz, P.; Yin, H.; Buttlar, W. 2013. Two-Dimensional Stress Analysis of Low-Temperature Cracking in Asphalt Overlay/Substrate Systems, Journal of Materials in Civil Engineering 25(9): 1228–1238. http://dx.doi.org/10.1061/(ASCE)MT.1943-5533.0000716

Pszczoła, M.; Judycki, J. 2009. Testing of Low Temperature Behaviour of Asphalt Mixtures in Bending Creep Test, in Proc. of the 7th International RILEM Symposium ATCBM09 on Advanced Testing and Characterization of Bituminous Materials”. 2009. Rhodes, CRC Press Taylor & Francis Group, 303–312.

Pszczoła. M. 2006. Low Temperature Cracking of Asphalt Layers of Pavements. PhD thesis. Gdansk University of Technology. 220 p.

Qian, G.; Zheng, J.; Wang, Q. 2007. Calculating Thermal Stresses of Asphalt Pavements in Environmental Conditions, Pavements and Materials 78–87. http://dx.doi.org/10.1061/40986(326)8

Rajbongshi, P. 2011. Comparative Study on Temperature Stresses in Asphalt Material Using Nonlinear Viscoelastic Approach, Journal of Transportation Engineering 137(10): 717–722. http://dx.doi.org/10.1061/(ASCE)TE.1943-5436.0000261

Sebaaly, P. E.; Lake, A.; Epps, J. 2002. Evaluation of Low-Temperature Properties of HMA Mixtures, Journal of Transportation Engineering 128(6): 578–586. http://dx.doi.org/10.1061/(ASCE)0733-947X(2002)128:6(578)

Tabatabaee, H. A.; Velasquez, R.; Bahia, H. U. 2012. Predicting Low Temperature Physical Hardening in Asphalt Binders, Construction and Building Materials 34(9): 162–169. http://dx.doi.org/10.1016/j.conbuildmat.2012.02.039

Van der Poel, C. 1954. A General System Describing the Viscoelastic Properties of Bitumen and Its Relation to Routine Test Data, Journal of Applied Chemistry 4: 221–236. http://dx.doi.org/10.1002/jctb.5010040501

Vervaecke, F.; Vanelstraete, A. 2008. Resistance to Low Temperature Cracking of High Modulus Bituminous Binders and Mixtures, Road Materials and Pavement Design (Supplement 1): 163–176. http://dx.doi.org/10.1080/14680629.2008.9690164

Wang, D.; Linbing, W.; Christian, D.; Zhou, G. 2013. Fatigue Properties of Asphalt Materials at Low in-Service Temperatures, Journal of Materials in Civil Engineering 25(9): 1220–1227. http://dx.doi.org/10.1061/(ASCE)MT.1943-5533.0000694

Yiqiu, T.; Lei, Z.; Lun, J. 2012. Analysis of the Evaluation Indices from TSRST, Journal of Materials in Civil Engineering 24(10): 1310–1316. http://dx.doi.org/10.1061/(ASCE)MT.1943-5533.0000509

Zeng, H. 1995. On the Low Temperature Cracking of Asphalt Pavements. PhD thesis. Royal Institute of Technology, Stockholm, Sweden. TRITA-IP FR 95-7, ISSN 1104-683X, ISRN KTH/IP/ FR-95/7-SE.

Zhong, Y.; Geng, L. 2009. Thermal Stresses of Asphalt Pavement with Temperature Dependent Modulus of Elasticity, in Proc. of the 8th International Conference (BCR2A’), Bearing Capacity of Roads, Railways and Airfields. 2009. University of Illinois at Urbana Champaign, Illinois, USA.

Zofka, A.; Marasteanu, M.; Turos, M. 2008. Investigation of Mixture Creep Compliance at Low Temperatures, Road Materials and Pavement Design 9 (Supplement 1): 269–285. http://dx.doi.org/10.1080/14680629.2008.9690169

Downloads

Published

27.03.2015

How to Cite

Pszczoła, M., & Judycki, J. (2015). Comparison of Calculated and Measured Thermal Stresses in Asphalt Concrete. The Baltic Journal of Road and Bridge Engineering, 10(1), 39-45. https://doi.org/10.3846/bjrbe.2015.05