Mechanistic Responses of Asphalt Concrete Overlay Over Jointed Plain Concrete Pavement Using Finite Element Method

Amadou Oury Diallo, Muhammet Vefa Akpinar

Abstract


This study focused on the development of a three-dimensional Finite Element Model of an asphalt concrete overlaid on a jointed plain concrete pavement to assess the mechanical behaviour of the pavement under traffic load. The objective of this study was to determine the influence of different asphalt concrete thickness, asphalt concrete modulus, the interface bond between the asphalt concrete and the Portland cement concrete layer, Portland cement concrete modulus, and joint width on the tensile strain at the bottom of the asphalt overlay. The results showed that changes in the pavement parameters result in a large range of variations on the magnitude of pavement responses. The magnitude of the longitudinal tensile strain at the bottom of the overlay varied between 25 με and 460 με. Asphalt concrete thickness, interface contact condition, and asphalt concrete modulus parameters had the most influence on the pavement responses. The interface bonding condition was significant, regardless of the thickness of the surface layer.

Keywords:

asphalt overlay; Finite Element Model (FEM); Portland cement concrete (PCC); reflective cracking

Full Text:

PDF

References


Al-Qadi, I. L., Carpenter, S. H., Leng, Z., Ozer, H., & Trepanier, J. (2009). Tack coat optimisation for HMA overlays: accelerated pavement test report. Illinois Center for Transportation (ICT).

Amini, F. (2005). Potential applications of paving fabrics to reduce reflective cracking (No. FHWA/MS-DOT-RD-05-174). The United States Federal Highway Administration.

Cable, J. K., Fanous, F. S., Ceylan, H., Wood, D., Frentress, D., Tabbert, T. R., ... & Gopalakrishnan, K. (2005). Design and Construction Procedures for Concrete Overlay and Widening of Existing Pavements.

Fallah, S., & Khodaii, A. (2015). Reinforcing overlay to reduce reflection cracking; an experimental investigation. Geotextiles & Geomembranes, 43(3), 216-227. https://doi.org/10.1016/j.geotexmem.2015.03.002

Francois, F. B., Larson, T. D., Pennsylvania, S., Borchert, J. R., Braun, R. P., Dustin, A. G., & Manheim, M. L. (1982). Minimising Reflection Cracking of Pavement Overlays National Cooperative Highway Research Program, National Cooperative Highway Research Program, National Research Council, Washington, DC).

Freeman, T. E., & Board, V. C. T. (2002). Evaluation of concrete slab fracturing techniques in mitigating reflective cracking through asphalt overlays (No. VTRC-03-R3). Virginia Transportation Research Council.

Huang, Y. H. (1993). Pavement analysis and design.

Kumara, W., Tia, M., Wu, C. L., & Choubane, B. (2003). Evaluation of applicability of ultrathin white topping in Florida. Transportation research record, 1823(1), 39-46. https://doi.org/10.3141%2F1823-05

Lytton, R. L. (1989). Use of geotextiles for reinforcement and strain relief in asphalt concrete. Geotextiles & Geomembranes, 8(3), 217-237. https://doi.org/10.1016/0266-1144(89)90004-6

Lytton, R. L., Tsai, F. L., Lee, S. I., Luo, R., Hu, S., & Zhou, F. (2010). Models for predicting reflection cracking of hot-mix asphalt overlays (No. Project 01-41). https://doi.org/10.17226/14410

Nunn, M. E. (1989). An investigation of reflection cracking in composite pavements in the United Kingdom. Proceedings of 1st International RILEM Conference on Reflective Cracking in Pavements, Assessment & Control, Liege University, Belgium.

Ozer, H., Al-Qadi, I. L., Wang, H., & Leng, Z. (2012). Characterisation of interface bonding between hot-mix asphalt overlay and concrete pavements: modelling and in-situ response to accelerated loading. International Journal of Pavement Engineering, 13(2), 181-196. https://doi.org/10.1080/10298436.2011.596935

Pavement Consultancy Services (1991). Guidelines and methodologies for the rehabilitation of rigid highway pavements using asphalt concrete overlay.

Shen, S., Zhang, W., Wang, H., & Huang, H. (2017). Numerical evaluation of surface-initiated cracking in flexible pavement overlays with field observations. Road Materials & Pavement Design, 18(1), 221-234. https://doi.org/10.1080/14680629.2016.1138879

Sobhan, K., & Tandon, V. (2008). Mitigating reflection cracking in asphalt overlays using geosynthetic reinforcements. Road Materials & Pavement Design, 9(3), 367-387. https://doi.org/10.1080/14680629.2008.9690124

Thompson, M. K., & Thompson, J. M. (2017). ANSYS mechanical APDL for finite element analysis. Butterworth-Heinemann.

Williamson, M. J. (2015). Finite element analysis of hot-mix asphalt layer interface bonding (Doctoral dissertation, Kansas State University).




DOI: 10.7250/bjrbe.2020-15.508

Refbacks

  • There are currently no refbacks.


Copyright (c) 2020 Amadou Oury Diallo, Muhammet Vefa Akpinar

Creative Commons License
This work is licensed under a Creative Commons Attribution 4.0 International License.