Performance Characteristics of the Open-Graded Asphalt Concrete Filled With a Special Cement Grout
DOI:
https://doi.org/10.3846/bjrbe.2015.40Keywords:
asphalt skeleton, cement grout, low temperature characteristics, permanent deformation, semi-rigid layer, skid resistance, stiffness modulusAbstract
This paper presents a performance of the open-graded asphalt concrete filled with a special cement grout in the road structures, introduces practical examples of the usage of this technology and defines the main properties. In addition, laboratory design of asphalt mixtures filled with special grout is researched. Finally, the results obtained from various laboratory tests are evaluated. The paper contains the open-graded asphalt concrete filled with a special cement grout mix design procedure and results of stiffness measurement, low temperature properties, permanent deformation and skid resistance. Open-graded asphalt concrete filled with a special cement grout mixture is compared to the commonly used asphalt mixes. The open-graded asphalt concrete filled with a special cement grout showed better results than the commonly used asphalt mixes by the stiffness and resistance to the permanent deformation characteristics but behavior at the low temperatures is slightly problematic.References
Al-Qadi, I. L.; Gouru, H.; Weyers, R. E. 1994. Asphalt Portland Cement Concrete Composite: Laboratory Evaluation, Journal of Transport Engineering 120(1): 94–108. http://dx.doi.org/10.1061/(ASCE)0733-947X(1994)120:1(94)
Anderton, G. L. 2000. Engineering Properties of Resin Modified Pavement (RMP) for Mechanistic Design. Geotechnical Laboratory, USA Army Engineer Research and Development Center. Vicksburg, Mississippi. 212 p.
Battey, R.; Whittington, E. 2007. Construction, Testing and Performance Report on the Resin Modified Pavement Demonstration Project. Report No. FHWA/MS-DOT-RD-07-137. Mississippi Dept of Transportation, Research and Development Division, Jackson, Mississippi. Federal Highway Administration, Washington D.C. 169 p.
Bhasin, A.; Motamed, A. 2011. Analytical Models to Characterise Crack Growth in Asphaltic Materials and Healing in Asphalt Binders, International Journal of Pavement Engineering 12(4): 371–383. http://dx.doi.org/10.1080/10298436.2011.575140
Bražiūnas, J.; Sivilevičius, H.; Virbickas, R. 2013. Dependences of SMA Mixture and Its Bituminous Binder Properties on Bitumen Batching System, Mixing Time and Temperature on Asphalt Mixing Plant, Journal of Civil Engineering and Management 19(6): 862–872. http://dx.doi.org/10.3846/13923730.2013.843587
Breakah, T. M.; Bausano, J. P.; Williams R. C.; Vitton, S. 2011. The Impact of Fine Aggregate Characteristics on Asphalt Concrete Pavement Design Life, International Journal of Pavement Engineering 12(2): 101–109. http://dx.doi.org/10.1080/10298430903578937
Collop, A. C.; Elliott, R. C. 1999. Assessing the Mechanical Performance of Densiphalt, in Proc. of the 3rd European Symposium on Performance and Durability of Bituminous Materials and Hydraulic Stabilised Composites. Ed. by Cabrera, J. G.; Zoorob, S. E.; Cabrera, S. G. 11–12 April 1999, Leeds, United Kingdom. 343–357.
Ding, Q.; Sun Z.; Shen, F.; Huang, S. 2011. The Performance of Semi-Flexible Pavement by the Volume Parameter of Matrix Asphalt Mixture, Advanced Materials Research (168– 180): 351–356. http://dx.doi.org/10.4028/www.scientific.net/AMR.168-170.351
Gawedzinki, M. J. 2008. Evaluation of Semi-Flexible (Resin Modified) Pavement. Report No. I2008-1, Springfield, Illinois, USA. 80 p.
Hajj, E. Y.; Tannoury, G.; Sebaaly, P. E. 2011. Evaluation of Rut Resistant Asphalt Mixtures for Intersection, Road Materials and Pavement Design 12(2): 263−292. http://dx.doi.org/10.1080/14680629.2011.9695246
Jacobsen, S. 2012. The Effectiveness of Grouted Macadam at Intersections – a Life-Cycle Cost Perspective: Degree Project in Highway Engineering. Division of Road and Railway Engineering, Department of Transport Science (TSC), Royal Institute of Technology (KTH), Stockholm, Sweden. 101 p.
Kanerva, H. K.; Vinson, T. S.; Zeng, H. 1994. Low Temperature Cracking: Field Validation of the Thermal Stress Restrained Specimen Test. SHRP-A-401. Strategic Highway Research Program, National Research Council, Washington D.C. 74 p. Available from Internet: http://onlinepubs.trb.org/online- pubs/shrp/SHRP-A-401.pdf
Laurinavičius, A.; Čygas, D. 2003. Thermal Conditions of Road Pavements and Their Influence on Motor Traffic, Transport 18(1): 22–31. http://dx.doi.org/10.1080/16483840.2003.10414059
Lenfant, M. 2012. High Rutting Resistant Asphalt Pavement. Seminar 2012: Dept of Highways. Tipco Asphalt Public Company Limited. 269–290.
Liu, C.; Wang, Z. 2003. Effect of Narrow Traffic Lanes on Pavement Damage, International Journal of Pavement Engineering 4(3): 177–180.
http://dx.doi.org/10.1080/1029843042000198586
Oliveira, J. R. M.; Thom, N. H.; Zoorob, S. E. 2006. Fracture and Fatigue Strength of Grouted Macadams, in Proc. of the 10th International Conference on Asphalt Pavements. 12−17 August 2006, Quebec, Canada. 1–10.
Oscarsson, E. 2011. Modelling Flow Rutting in in-Service Asphalt Pavements Using the Mechanistic-Empirical Pavement Design Guide, Road Materials and Pavement Design 12(1): 37–56.
http://dx.doi.org/10.1080/14680629.2011.9690351
Sivilevičius, H.; Vansauskas, V. 2013. Research and Evaluation of
Ruts in the Asphalt Pavement on Lithuanian Highways, Journal of Civil Engineering and Management 19(5): 609–621. http://dx.doi.org/10.3846/13923730.2013.817481
Sun, Z. H. 2007. Research on Crack Resistance of Cement Stabilized Macadam Base Course, Journal of Building Materials 10(1): 59–65 (in Chinese).
Tarefder, R. A.; Zaman, M.; Hobson, K. 2003. A Laboratory and Statistical Evaluation of Factors Affecting Rutting, International Journal of Pavement Engineering 4(1): 59–68. http://dx.doi.org/10.1080/10298430310001593263
Uddin, W. 2003. Effects of FWD Load-Time History on Dynamic Response Analysis of Asphalt Pavement, in Proc. of the 3rd International Symposium on Maintenance and Rehabilitation of Pavements and Technological Control “MAIREPAV03”. Ed. by Pereira, P.; Branco, F. 7–10 July 2003, University of Minho, Guimarães, Portugal.
Wu, D. Q.; Zhang, Y. 2011. The Semi-Rigid Pavement with Higher Performances for Roads and Parking Aprons, in Proc. of the CAFEO 29, Sustainable Urbanization – Engineering Challenges and Opportunities. 27–30 November 2011, Negara, Brunei. 1–7.
Xu, T.; Huang, X. 2012. Investigation into Causes of in-Place Rutting in Asphalt Pavement, Construction and Building Materi- als 28(1): 525–530. http://dx.doi.org/10.1016/j.conbuildmat.2011.09.007
Vaitkus, A.; Laurinavičius, A.; Oginskas, R.; Motiejūnas, A.; Paliukaitė, M.; Barvidienė, O. 2012. The Road of Experimental Pavement Structures: Experience of Five Years Operation, The Baltic Journal of Road and Bridge Engineering 7(3): 220– 227. http://dx.doi.org/10.3846/bjrbe.2012.30
Vaitkus, A.; Paliukaitė, M. 2013. Evaluation of Time Loading Influence on Asphalt Pavement Rutting, Procedia Engineering 57(1): 1205–1212.
http://dx.doi.org/10.1016/j.proeng.2013.04.152
Van de Ven, M. F.; Molenaar, A. A. 2004. Mechanical Characterization of Combi-Layer, Journal of the Association of Asphalt Paving Technologists 73: 1–22.
Zhuang, S. Q.; Liu, P.; Sun, Z. P. 2003. Investigation on Deformation and Its Influencing Factors of Cement-Stabilized Macadam Base, Journal of Building Materials 6(4): 356–363 (in Chinese).
Downloads
Published
Issue
Section
License
Copyright (c) 2015 Vilnius Gediminas Technical University (VGTU) Press Technika
This work is licensed under a Creative Commons Attribution 4.0 International License.
How to Cite
