Evaluation of Horizontal Curve Radius Effect on Driving Speed in Two Lane Rural Road. Pilot Study





design speed (Vd), horizontal curve, low-volume road, operating speed (V85), regional road


This paper presents a case study of driving speed at horizontal curves in the regional road. The literature review of operating speed at horizontal curves in regional roads expresses the difference between design speed and driving speed. Driving speed was measured in ten horizontal curves on regional road No. 2610. Collected data was compared to the design speed, various design standards, and Operating Speed Prediction Models for traffic in low-volume roads. Based on result analysis, was proposed initial adjusted minimum radius of the horizontal curve based on operating speed. It is justified that proposed corrections based on operating speed ensure a credible speed limit effect on road safety. The performed experiment showed different tendencies comparing measured driving speed with permitted and design speeds. It was determined that dependent on specific curved section drivers tend to exceed posted speed limit from 17% to 98% of cases, and from 41% to 100% − the design speed in the horizontal curve. This research led to identifying the limitations of experimental research methodology. These limitations are related to experimental Site selection with different combinations of alignment elements, traffic, and accident data. A pilot study showed significant results and gave essential insights into the full-scale research plan. The results are expected to benefit both other researchers and the organisations responsible for the development and implementation of normative technical documents for road design.


Aarts, L., van Nes, N., Donkers, E., & van der Heijden, D. (2010). Towards safe speeds and credible speed limits. In 4th International Symposium on Highway Geometric Design, Polytechnic University of Valencia, Transportation Research Board.

American Association of State Highway Transportation Officials (AASHTO) (2018). A Policy on Geometric Design of Highways and Streets 2018 (7th).

Abbas, S. K. S., Adnan, M. A., & Endut, I. R. (2011). Exploration of 85th percentile operating speed model on horizontal curve: a case study for two-lane rural highways. Procedia – Social & Behavioral Sciences, 16, 352-363. https://doi.org/10.1016/j.sbspro.2011.04.456

Camacho-Torregrosa, F. J., Pérez-Zuriaga, A. M., Campoy-Ungría, J. M., & García-García, A. (2013). New geometric design consistency model based on operating speed profiles for road safety evaluation. Accident Analysis & Prevention, 61, 33-42. https://doi.org/10.1016/j.aap.2012.10.001

Castro, M., Pardillo-Mayora, J. M., & Jurado, R. (2013). Development of a local operating speed model for consistency analysis integrating laser, GPS and GIS for measuring vehicles speed. The Baltic Journal of Road and Bridge Engineering, 8(4), 281-281. https://doi.org/10.3846/bjrbe.2013.36

DHV Environment and Transportation (2005). Sustainable safe road design: a practical manual. September, 218.

Dilling, J. (1973). Fahrverhalten von Kraftfahrzeugen auf kurvigen Strecken. Research Report. In Strassenbau und Strassenverkehrstechnik. Bonn-Bad Godesberg, Germany. (in German)

Elliott, M., Dawson, R. & Edwards, J. (2006). Towards real process improvement from internal auditing - a case study. Software Quality Journal 14, 53–64. https://doi.org/10.1007/s11219-006-6001-3

Elvik, R. (2014). Fart og trafikksikkerhet: nye modeller. TØI Transportøkonomisk institutt. (in Swedish)

European Commission (2015). Speed and Speed Management 2015. In European Commission, Directorate General for Transport.

European Conference of Ministers of Transport, & OECD/ECMT Transport Research Centre. (2006). Speed management. In OECD/ECMT Transport Research Centre (Vol. 4).

Gintalas, V. (2010). Possibilities for the improvement of the quality of design solutions in the gravel road reconstruction projects. The Baltic Journal of Road and Bridge Engineering, 5(3), 177-184. https://doi.org/10.3846/bjrbe.2010.25

Goldenbeld, C., & van Schagen, I. (2007). The credibility of speed limits on 80 km/h rural roads: The effects of road and person (ality) characteristics. Accident Analysis & Prevention, 39(6), 1121-1130. https://doi.org/10.1016/j.aap.2007.02.012

Kanellaidis, G., Golias, J., & Efstathiadis, S. (1990). Drivers’ speed behaviour on rural road curves. Traffic Engineering and Control, 31(7-8), 414-415.

Lamm, R., Beck, A., Ruscher, T., Mailänder, T., Cafiso, S., & La Cava, G. (2007). How to make two-lane rural roads safer: scientific background and guide for practical application. Southampton, UK; Boston, MA: WIT Press.

Lamm, R., & Choueiri, E. M. (1987). Recommendations for evaluating horizontal design consistency based on investigations in the state of New York. Transportation Research Record, 1122, 68-78.

Lamm, R., Psarianos, B., & Mailaender, T. (1999). Highway design and traffic safety engineering handbook.

Misaghi, P., & Hassan, Y. (2005). Modeling operating speed and speed differential on two-lane rural roads. Journal of Transportation Engineering, 131(6), 408–418. https://doi.org/10.1061/(ASCE)0733-947X(2005)131:6(408)

The Ministry of Transport and Communications of the Republic of Lithuania (2019). State traffic safety improvement program “Vision – Zero”, Resolution of the Government of the Republic of Lithuania, Reg. No. 19-3, 32. (in Lithuanian)

Srinivasan, R., Parker, M., Harkey, D., Tharpe, D., & Sumner, R. (2006). Expert system for recommending speed limits in speed zones. National Cooperative Highway Research Program, Transportation Research Board, National Research Council. Project No. 3-67.

SWOV (2013). Sustainable safety: principles, misconceptions, and relations with other visions. July, 1–6.

Vadeby, A., & Forsman, Å. (2014). Evaluation of new speed limits in Sweden: A sample survey. Traffic Injury Prevention, 15(8), 778-785. https://doi.org/10.1080/15389588.2014.885650

Wang, B., Hallmark, S., Savolainen, P., & Dong, J. (2018). Examining vehicle operating speeds on rural two-lane curves using naturalistic driving data. Accident Analysis & Prevention, 118, 236-243. https://doi.org/10.1016/j.aap.2018.03.017

Washington, S., Karlaftis, M. G., Mannering, F., & Anastasopoulos, P. (2020). Statistical and econometric methods for transportation data analysis. CRC press. https://doi.org/10.1201/9780429244018

World Health Organization (2018). Global Status Report on Road Safety 2018.




How to Cite

Šeporaitis, M., Vorobjovas, V., & Vaitkus, A. (2020). Evaluation of Horizontal Curve Radius Effect on Driving Speed in Two Lane Rural Road. Pilot Study. The Baltic Journal of Road and Bridge Engineering, 15(4), 252-270. https://doi.org/10.7250/bjrbe.2020-15.503